News center

Adjustment procedure of electric film reeler
Time:2020.03.21 Source:Taizhou Nongyun Technology Co., Ltd Views:

In the adjustment procedure of electric film coiler, the driving shaft of the film coiler in the shed can rotate about 50 turns (about 9 minutes). When the 25 mm film coiler is used, the width of the film coiler is about 4 M.

1. Fix the film winder in the middle of film spreading, connect the power supply to make the motor run, and change the motor direction several times to test whether the motor works normally.

2. The driving shaft of the film winder in the shed can rotate about 50 turns (about 9 minutes). When the 25 mm film winder is used, the width of the film winder is about 4 M.

3. As shown in the figure, the limit switch part of the film coiler in the shed is set to 0 when the product leaves the factory. When the 25 mm film coiler is used as the driving shaft, the height of each large scale film coiler is about 0.2 m, and the height of each five large scale film coiler is about 1 m.

4. When adjusting the limit switch, first slightly press the adjustment knobs A and B, slightly rotate the adjustment knobs A and B, and rotate to the appropriate scale according to the actual required film rolling width.

5. After the limit switch is adjusted, run it repeatedly for several times to test whether the limit switch works normally and adjust it to a good working state at the same time.

6. Once the limit switch is adjusted, please do not change it at will.

Return list